Net Metering Explained: How Solar Export Credits Work in 2026

By Jensen Lee · Last updated: November 2026

When your solar panels produce more electricity than your home is using, that extra power does not disappear — it flows out to the grid. What you get paid for it is decided by your utility’s export policy, and in 2026 that policy is one of the biggest factors in whether solar pays off. This guide explains how net metering works, how it differs from the newer “net billing” arrangements replacing it, what your exports are actually worth under each system, and how to find the policy that applies to your home.

What net metering is, in plain terms

Net metering is a billing arrangement that lets you use the grid like a battery. Your meter tracks two flows of electricity:

  • Imports — electricity you pull from the grid (at night, on cloudy days, whenever your panels are not covering your usage)
  • Exports — surplus solar electricity you push out to the grid (typically midday, when production peaks and home usage is low)

Under classic net metering, your bill is based on the net of those two flows over the billing period. Export a kilowatt-hour at noon, import a kilowatt-hour at 9 p.m., and the two cancel out — as if your meter had literally spun backward during the day and forward again at night. That is where the “spinning the meter backward” image comes from: older analog meters genuinely did run in reverse when a home exported power.

The key number is the export credit rate — what each exported kWh earns you. Under full net metering, exports are credited at the full retail rate (the same ~17¢/kWh average, or 25–40¢ in high-cost states, that you pay for imports). Under newer policies, exports are credited at much lower rates. Everything below follows from that difference.

How a net metering bill works: a worked example

Say your home uses 1,000 kWh in a month, and your solar system produces 800 kWh. But production and usage do not happen at the same times, so the flows matter more than the totals:

FlowAmountWhat happens
Total solar production800 kWhGenerated across the month
Used instantly by your home (self-consumption)480 kWhNever touches the meter; saves full retail value
Exported to the grid320 kWhCredited under your export policy
Imported from the grid520 kWhBilled at your retail rate
Total home usage1,000 kWh480 self-consumed + 520 imported

Now compare the bill at an average retail rate of 17¢/kWh:

  • Under 1:1 net metering: exports offset imports one-for-one. You are billed on net imports: 520 − 320 = 200 kWh × 17¢ = $34 (plus fixed connection fees, typically $10–$20/month).
  • Under net billing at a 5¢ export rate: you pay full price for all imports (520 × 17¢ = $88.40) and receive a separate credit for exports (320 × 5¢ = $16). Bill: $72.40 plus fixed fees.

Same panels, same house, same month — the bill more than doubles purely because of the export policy. Without solar at all, the bill would have been $170. Net metering still saves a lot under either policy, but the policy decides how much, and it decides how fast the system pays for itself.

Note the role of self-consumption in the table: the 480 kWh your home used the instant it was generated is worth the full retail rate under every policy, because it never becomes an import. That fact drives a lot of the advice later in this guide.

1:1 retail crediting vs. reduced export rates

Full (1:1) net metering credits exports at the full retail rate, usually with monthly rollover — surplus credits earned in a sunny month carry forward to offset a cloudier one, often with an annual “true-up” where leftover credits expire or are paid out at a low rate. This was the standard US policy for two decades and is still the most generous arrangement for solar owners.

Reduced export rates come in several forms:

  • Avoided-cost / wholesale crediting: exports are paid at roughly what it costs the utility to generate or buy power itself — typically 2–6¢/kWh.
  • Time-varying export rates: exports are priced by hour and season, worth more on hot summer evenings when the grid is strained and very little on mild spring middays when solar is abundant.
  • Fixed export tariffs: a set rate (say 5¢/kWh) regardless of when you export.

The trend across the US is one-directional: state after state has moved new solar customers from 1:1 crediting toward reduced export rates, usually while grandfathering existing customers on the old terms for a set period (more on that below).

California’s NEM 3.0: the “net billing” shift everyone is watching

California is the largest solar market in the US, and in April 2023 its rules changed so dramatically that they reshaped the national conversation. Under the previous policy (NEM 2.0), exports were credited near the retail rate. Under the successor policy — officially a “net billing tariff,” widely called NEM 3.0 — exports are credited at rates based on the utility’s avoided cost: what that energy is actually worth to the grid at that hour.

The practical result:

  • Average export values fell by roughly 75% — from near-retail credits (often ~25–30¢/kWh) to typical values around 2–8¢/kWh, varying by hour, season, and utility.
  • Midday spring exports — when California has more solar than it can use — can be worth close to zero. Exports on summer evenings, when the grid is desperate for power, are worth far more, sometimes 30¢+/kWh.
  • The economics flipped from “export everything, import at night” to “use your own power, or store it.” Attaching a battery and discharging it during the expensive evening hours became close to essential for good payback under NEM 3.0, and California installers now pair batteries with the large majority of new systems.

Other states have watched California closely. Hawaii ended retail net metering years earlier (in 2015) and moved to reduced-rate export programs. Nevada cut export rates in 2015, then largely restored retail-rate net metering in 2017 — a reminder that these policies are political as well as technical, and they can move in either direction. Arizona, Indiana, and several others have replaced retail net metering for new customers with lower export rates set in utility rate cases.

Which states still have strong net metering?

Policies change constantly, but as of 2026 the picture looks roughly like this. Treat it as a starting point for checking your own utility, not as a guarantee — the details live at the utility level, not just the state level.

Policy environmentExamplesWhat it means for you
Statewide retail-rate net metering still broadly availableNew Jersey, Massachusetts, Maryland, Colorado, Illinois (with program-specific details)Exports offset imports close to 1:1; solar-only systems pencil out well
Retail net metering with caps, charges, or successor tariffs in motionNew York (net metering for small residential, with grid-access charges), Connecticut, Minnesota, OregonStill favorable, but read the fine print on fixed charges and credit rollover
Reduced export rates / net billing for new customersCalifornia, Hawaii, Arizona, Indiana, Nevada (partially restored)Self-consumption and batteries matter much more; payback is longer for solar-only
No statewide policy — set utility by utilityTexas, most of the Southeast and PlainsYour retail electricity plan decides; some Texas plans offer true 1:1 buyback, others pay wholesale

Two cautions. First, even in “strong” states, utilities may add fixed monthly charges for solar customers or minimum bills, which trim savings without touching the export rate. Second, municipal utilities and rural cooperatives often run their own policies entirely separate from the state rules that apply to investor-owned utilities. Your meter, your utility, your rules.

Net metering vs. net billing vs. buy-all/sell-all

Three arrangements cover almost every US solar home:

  • Net metering: one meter (or one meter reading both directions), imports and exports netted against each other, exports effectively valued at or near retail. You are billed on the difference.
  • Net billing: imports and exports are priced separately and never netted. You buy everything you import at retail and sell everything you export at the export rate (usually avoided-cost based). California’s NEM 3.0 is net billing. Your bill shows both lines.
  • Buy-all / sell-all: you buy all your home’s electricity from the grid at retail and sell all your solar production to the utility at a set rate — even the power your home uses the instant it is made. Self-consumption earns you nothing extra. This is the least favorable structure for homeowners and appears mainly in some cooperative and municipal territories and in certain feed-in tariff programs.

If you are comparing quotes in different territories, identify which of the three structures applies before comparing any payback numbers. A system that pays back in 7 years under net metering can take 12 under buy-all/sell-all.

How export policy changes the payback math

Recall the anchors used across MyWattGuide: a typical 6–8 kW system costs $18,000–$31,000 installed ($2.50–$3.50/W) before incentives — and note that the 30% federal residential tax credit ended on December 31, 2025, so state incentives and export policy now carry the whole economic case.

The worked example above shows why. In that month, the system produced 800 kWh. Under 1:1 net metering, effectively all 800 kWh were worth the retail rate (self-consumed or offset), saving about $136. Under net billing at 5¢, the self-consumed 480 kWh saved $81.60 and exports earned $16 — about $98 total, roughly 28% less for identical hardware. Spread across a year and a 25-year system life, that difference is worth several thousand dollars and typically adds 2–4 years to the payback period.

Installers know this, which is why a trustworthy 2026 quote models your actual utility policy. If a proposal assumes retail-rate crediting and your utility pays 5¢ for exports, the payback figure on that proposal is fiction.

Why batteries pair with net billing

Under 1:1 net metering, a battery adds little bill savings — the grid already “stores” your surplus at full value. Under net billing, the arithmetic reverses:

  • Export a kWh at midday: earn ~5¢.
  • Store that kWh and use it at 7 p.m.: avoid buying a kWh at 17¢ — or at 30–40¢ on time-of-use evening rates.

That spread is the entire case for storage under net billing. A home battery (10–13.5 kWh, roughly $9,000–$15,000 installed) shifts your midday surplus into your evening peak, raising self-consumption from a typical 30–50% (solar only) to 70–90%. Under California-style rates, that shift is often the difference between a 12-year payback and an 8-year one. Under strong net metering, the same battery is mostly backup insurance — valuable, but not a money-saver. Know which situation you are in before pricing one.

Practical self-consumption boosters that cost nothing: run the dishwasher, laundry, pool pump, and EV charging during solar hours. Every kWh you use as it is generated is a kWh bought back at full retail value under any policy.

Grandfathering: the clause that protects (and traps) existing owners

When states cut export rates, they almost always grandfather existing solar customers on their old terms for a defined period — commonly 10–20 years from the system’s installation (California’s NEM 2.0 customers, for example, keep their terms for 20 years). This matters in three ways:

  1. Your install date locks your policy. Two identical systems on the same street can operate under completely different economics depending on when they were installed.
  2. Changes can end grandfathering. Expanding your system beyond a small allowance (California allows roughly 10% or 1 kW) or changing account ownership in some circumstances can push you onto the new tariff. Check before adding panels.
  3. It cuts both ways when buying a home. A house with a grandfathered system may carry genuinely better solar economics than a new install next door — worth asking about, and worth verifying with the utility rather than the seller.

How to find your utility’s current policy

Do not rely on an installer’s summary or a neighbor’s 2021 experience. Check the primary sources:

  1. Your utility’s website — search for “net metering,” “net billing,” “interconnection,” or “solar buyback.” The tariff sheet (a formal rate document) is the ground truth.
  2. DSIRE (dsireusa.org) — the Database of State Incentives for Renewables & Efficiency tracks state net metering rules and links to utility programs. Enter your ZIP code.
  3. Your state public utility commission — export policies are set in formal proceedings; commission sites publish current tariffs and pending changes.
  4. Your own bill — if you already have solar, your bill shows exactly how exports are credited today. Look for separate import/export lines (net billing) or a single netted figure (net metering).

Ask any installer to put the assumed export rate in writing on the proposal. A good one will — it is the number their whole savings model stands on.

Frequently asked questions

Does net metering mean my electric bill goes to zero?
Almost never completely. Even with perfect 1:1 netting you still pay fixed monthly connection fees (typically $10–$20), and if you import more than you export across the year you pay for the difference. Most solar homes see bills drop 50–90%, not vanish — and under net billing, where exports earn less than imports cost, a true zero bill is essentially impossible from netting alone.

What happens to my excess credits at the end of the year?
It depends on the policy. Many net metering programs roll credits forward month to month and “true up” annually, at which point leftover credits expire worthless or are paid out at a low avoided-cost rate (2–5¢/kWh). This is why installers size systems to roughly match annual usage rather than exceed it — oversizing earns you credits you will never be paid full value for.

If my state cuts net metering, do I lose my current rates?
Usually not immediately. Most policy changes grandfather existing systems on their original terms for 10–20 years from installation. The risks are at the margins: major system expansions, or rules written with shorter protection windows. Check your tariff’s grandfathering clause before modifying your system.

Is net metering or a battery a better investment?
They solve different problems. Strong net metering makes a battery unnecessary for savings — the grid does the storing. Weak export rates (net billing) make a battery the tool that restores the economics by raising self-consumption. If your export rate is under roughly a third of your retail rate, model the system with a battery included; if you have 1:1 crediting, spend the money on panels instead.

Do I need a special meter for net metering?
Your utility will install or configure a bidirectional meter that records imports and exports separately — this happens as part of the interconnection approval (Permission to Operate) after installation. There is usually no charge, or a modest one, and you cannot legally export power before that approval is in place.

Sources

Policy structures and program details are based on the DSIRE database (Database of State Incentives for Renewables & Efficiency, maintained with US Department of Energy support), California Public Utilities Commission decisions on the NEM 3.0 net billing tariff, state public utility commission tariff documents, and US Energy Information Administration (EIA) residential rate data. Market and adoption context from the Solar Energy Industries Association (SEIA) and Lawrence Berkeley National Laboratory’s Tracking the Sun research. Export rates and policies change frequently; verify your own utility’s current tariff before making decisions.

MyWattGuide is an independent information site, not an installer. Prices here are estimates, not quotes — see our Disclaimer.

Leave a Comment